• Wendy8540

Katherine

pay attention to Jebao pumps with speed control

Helen

Leave it as it is, you have Power 28 W Water lift 2 m Flow rate 1200 l/h Why do you need such a powerful Eheim universal 2400? Power 65 W Water lift 3.7 m Flow rate 2400 l/h. Your EHEIM universal 1200 l, which is even if it has dropped by 10%, will be more than enough for your volume! If you want to throw money away, do you want water heating, more energy consumption, and of course more noise? Then buy and install the Eheim universal 2400.

John5528

I want to place a reactor with biopellets in the chain, along with a reactor with coal and antifos, and at the end of the same chain, an algae scrubber similar to this one. I don't want to install an additional pump because in the end, I will get the same heat release into the water, but instead of one pump, there will be two.

Elijah7048

If I were to make a replacement, it would be for a DC adjustable Jcode (Jebao).

Earl

I didn't have and don't have any of this, Riff handles everything perfectly! Now it's up to you to think, but don't rush, consider everything carefully.

Zachary

Why? I have only used the EHEIM universal 1200, so I can't compare it to anything else. But I'm satisfied with this pump; it's quiet and works well, especially considering that the aquarium is next to the bed, which is quite an important issue. So I thought that more powerful models would be just as good.

Jennifer7578

safe (24V), adjustable, quiet (quiet), using 2 and 3 tons.

Stephen

I fully support this; without these devices, the rhythm is pleasing.

Kevin3114

I understand that none of this is essential; the trigger here is not a necessity for this equipment, but its interesting nature and the acquisition of practical experience in its use, to make more informed decisions in the future.

Brooke

Sounds interesting, I'll look up where I can buy them here on Google.

Curtis9143

I recommend

Sarah5423

Interesting scrubber, how much does it cost and what volume is it designed for?

John3187

I ordered a replica to be made, but while the scrubber is not ready, it's hard to say anything.