• pH и редокс контроллер Weipro PO 2310

  • Jason9952

Народ, инструкция на китайском. :-) Ни на одном знакомом языке не нашел. Может есть у кого? Помогите пож. :-)

John828

Operation: PH 1. AC230V-50/60HZ connect power. 2. PH PH electrode inserted into the input. 3. PH ORP will be set up to "PH" position, while the SET M setting, "SET" position, and then pH electrode Add to PH7 correction fluid, and a few seconds to show that value stability, with ching plastic, "the word" angry CALPH7 adjustment knob, so that was Numerical 7.00 to show after regulation, the pH electrode from the correction fluid extraction, pH electrode Add to the need to test the water. 4. SET M will be set up to the SET position adjustment knob until PHSET that need PH values, in general, aquatic plants cylinder in the PH - PH7.2 PH6.8 between the pH of seawater fish PH8.0 - PH8.4 in between. 5. Finally, the CO 2 system controller plugs inserted in the socket, while the SET M M to set up a position, at this time controller can use carbon dioxide released from the system to reduce carbon dioxide PH. ORP 1. The ORP electrode inserted ORP input. 2. PHORP ORP will be set up to the location, set up to the SET M SET position, and then ching plastic, "the word" angry ORP SET knobs adjust to meet the needs of that set numerical redox voltage value (generally the fish tank water plants ORP value-235mV 260mV, the ORP water fish tank in value between 300mv - 350mV) 3. Add to ORP electrode will be needed to control the water, then ozone machine plug in the power plug socket controller, the SET M final set to the "M" position, at this time, the controller on the use of ozone for the release of ozone, the redox potential value increased. Note: Feeding ago, after the daytime, evening and the PH level will affect the level of oxidation - reduction potential

Joshua448

погано шукали ((